Under publication
ISO 16486-4
Plastics piping systems for the supply of gaseous fuels — Unplasticized polyamide (PA-U) piping systems with fusion jointing and mechanical jointing — Part 4: Valves
Reference number
ISO 16486-4
Edition 3
2025-06
Under publication
ISO 16486-4
87593
Under publication (Edition 3, 2025)
Final production steps (up to seven weeks).
Will replace ISO 16486-4:2022

Abstract

This document specifies the characteristics of valves made from unplasticized polyamide (PA-U) in accordance with ISO 16486-1, intended to be buried and used for the supply of gaseous fuels.

NOTE 1        For the purpose of this document the term gaseous fuels include for example natural gas, methane, butane, propane, hydrogen, manufactured gas, biogas, and mixtures of these gases. Additional information about the suitability for 100 % hydrogen and its admixtures with natural gas is given by ISO 16486-1:2023, Annex C and Annex D.

It is applicable to isolating unidirectional and bi-directional valves with spigot ends or electrofusion sockets intended to be fused with PA-U pipes conforming to ISO 16486-2 and PA-U fittings conforming to ISO 16486-3.

This document also specifies the test parameters for the test methods it describes.

In conjunction with ISO 16486-1, ISO 16486-2, ISO 16486-3 and ISO 16486-5, this document is applicable to PA-U valves and their joints and to joints with components of PA-U and other materials intended to be used under the following conditions:

a)       a maximum operating pressure (MOP) of up to and including 18 bar1), or limited to 16 bar under regional CEN requirements, at a reference temperature of 20 °C for design purposes;

NOTE 2        For the purpose of this document and the references to ISO 8233, MOP is considered to be nominal pressure.

b)       an operating temperature of −20 °C to 40 °C;

NOTE 3        For operating temperatures between 20 °C and 40 °C, derating coefficients are specified in ISO 16486-5.

This document covers valves for pipes with a nominal outside diameter, dn, ≤400 mm.

General information

  •  : Under development
     : 2025-06
    : International Standard under publication [60.00]
  •  : 3
  • ISO/TC 138/SC 7
    75.200  83.140.30 
  • RSS updates

Got a question?

Check out our Help and Support