ISO 9624:2019

No disponible en español

Publicado (Edición 2, 2019)

Esta norma tiene 1 modificaciones.

ISO 9624:2019

CHF 129

Convertir Franco suizo (CHF) a tu moneda

Resumen

This document specifies the mating dimensions for thermoplastic flange adapters and corresponding loose backing flanges intended to be used in thermoplastic piping systems for the conveyance of fluids under pressure.

It applies to flange adapters and loose backing flanges for use with pipes with nominal outside diameters (d_n) from 16 mm to 2 500 mm and nominal pressures up to 25 bar[1] (PN 25).

This document specifies the dimensions of the flange adapters intended to be used for:

— butt fusion piping systems;

— socket fusion piping systems;

— adhesive jointed piping systems.

NOTE 1 For specific connections with dimensions (e.g. d_n450 or d_n630) not covered in this document, or specific equipment (butterfly valves), specific solutions are available on the market.

This document is applicable to loose backing flanges made from metal, thermoplastics, or a combination of metal and thermoplastics.

This document also provides information on gaskets and gives general recommendations on correct assembling practices.

NOTE 2 Industrial applications are not covered by this document. Products intended for industrial application are covered by ISO 15493^[1], ISO 15494 or ISO 10931^[2].

[1] 1 bar = 0,1 MPa = 10⁵ N/m².

Informaciones generales

Estado
: Publicado

Fecha de publicación
: 2019-07

Etapa
: Norma Internacional en proceso de revisión sistemática [90.20]
Edición
: 2

Número de páginas
: 19
Comité Técnico :
ISO/TC 138/SC 2

ICS :
23.040.60
RSS actualizaciones

Modificaciones

Las enmiendas se emiten cuando se decide que puede ser necesario agregar nuevo material a un documento de normalización existente. También pueden incluir correcciones editoriales o técnicas que deban aplicarse al documento existente.