Reference number
ISO 2360:2017
© ISO 2024
International Standard
ISO 2360:2017
Non-conductive coatings on non-magnetic electrically conductive base metals — Measurement of coating thickness — Amplitude-sensitive eddy-current method
Edition 4
2017-07
Preview
недоступно на русском языке
Опубликовано (Версия 4, 2017)
Последний раз этот публикация был пересмотрен в  2022. Поэтому данная версия остается актуальной.

ISO 2360:2017

Язык
Формат
CHF 151
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO 2360:2017 specifies a method for non-destructive measurements of the thickness of non-conductive coatings on non-magnetic electrically conductive base metals, using amplitude-sensitive eddy-current instruments.

In ISO 2360:2017, the term "coating" is used for materials such as, for example, paints and varnishes, electroplated coatings, enamel coatings, plastic coatings, claddings and powder coatings. This method is particularly applicable to measurements of the thickness of most oxide coatings produced by anodizing, but is not applicable to all conversion coatings, some of which are too thin to be measured by this method (see Clause 6).

This method can also be used to measure non-magnetic metallic coatings on non-conductive base materials. However, the phase-sensitive eddy-current method specified in ISO 21968 is particularly usable to this application and can provide thickness results with a higher accuracy (see Annex A).

This method is not applicable to measure non-magnetic metallic coatings on conductive base metals. The phase-sensitive eddy-current method specified in ISO 21968 is particularly useful for this application. However, in the special case of very thin coatings with a very small conductivity, the amplitude-sensitive eddy-current method can also be used for this application (see Annex A).

Although the method can be used for measurements of the thickness of coatings on magnetic base metals, its use for this application is not recommended. In such cases, the magnetic method specified in ISO 2178 can be used. Only in case of very thick coatings above approximately 1 mm, the amplitude-sensitive eddy-current method can also be used for this application (see Annex A).

Общая информация

  • Текущий статус
     : Опубликовано
    Дата публикации
     : 2017-07
    Этап
    : Подтверждение действия международного стандарта [90.93]
  • Версия
     : 4
  • Технический комитет :
    ISO/TC 107
    ICS :
    25.220.20 
  • RSS обновления

Жизненный цикл

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития

9
Индустриализация, инновации и инфраструктура

Появились вопросы?

Ознакомьтесь с FAQ

  2. Интернет-магазин
  3. Каталог стандартов
  4. МКС
  5. 25
  6. 25.220
  7. 25.220.20
  8. ISO 2360:2017