ISO/ASTM 52903-1:2020
p
ISO/ASTM 52903-1:2020
67290
недоступно на русском языке

Тезис

 Preview

This document describes a method for defining requirements for plastic materials used in extrusion-based additive manufacturing (AM) processes. Materials include unfilled, filled, and reinforced plastic materials suitable for processing into parts. These materials can also contain special additives (e.g. flame retardants, stabilizers, etc.). Processes include all material extrusion-based AM processes.

This document is intended for use by manufacturers of materials, feedstocks, plastic parts or any combination of the three using material extrusion-based AM.

NOTE In some cases, material manufacturers can also be feedstock manufacturers. In other cases, a material manufacturer can supply materials (example: pellets) to a feedstock manufacturer (example: converter of pellets into filaments).

This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health, and environmental practices and determine the applicability of regulatory limitations prior to use.


Общая информация 

  •  : Опубликовано
     : 2020-04
  •  : 1
  •  : ISO/TC 261 Additive manufacturing
  •  :
    25.030 Additive manufacturing

Приобрести данный стандарт

ru
Формат Язык
std 1 40 PDF + ePub
std 2 40 Бумажный
  • CHF40

Жизненный цикл

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)