ISO 15912:2016
p
ISO 15912:2016
63467
недоступно на русском языке
Текущий статус : Опубликовано (Hа стадии пересмотра)
Последний раз этот стандарт был пересмотрен в  2021. Поэтому данная версия остается актуальной
ru
Формат Язык
std 1 124 PDF
std 2 124 Бумажный
  • CHF124
Пересчитать швейцарские франки (CHF) в ваша валюта

Тезис

ISO 15912:2016 gives requirements and test methods for determining the compliance of dental casting investment, dental brazing investment, dental pressable-ceramic investment and dental refractory die materials used in the dental laboratory, regardless of the composition of the refractory powder, the composition of the binder, or the particular application.

ISO 15912:2016 classifies such products into types and classes, according to their intended use and the burn-out procedure recommended by the manufacturer.

It also gives requirements for marking, labelling and manufacturer's instructions.

It specifies requirements for the essential physical and mechanical properties of the products and the test methods to be used for determining them.

NOTE 1 Compliance with all of the requirements presented in Clause 5 may not be necessary for some products, and a requirement might not be applicable to a product with a particular binder chemistry or be intended for an application in which that requirement is irrelevant. When this is the case, a clear statement to this effect is given according to Clause 5.

NOTE 2 A specific quantitative requirement for setting expansion is not included in this International Standard. If the setting expansion of gypsum-bonded investment is measured, then the procedure given in ISO 6873[1] can be considered ? a procedure not recommended, however, for investment materials with other binders.

Общая информация

  •  : Опубликовано
     : 2016-01
    : Подтверждение действия между-народного стандарта [90.93]
  •  : 2
  • ISO/TC 106/SC 2
    11.060.10 
  • RSS обновления

Preview 

Предварительно ознакомьтесь с этим стандартом в нашем Он-лайн библиотека стандартов (OBP)

Жизненный цикл

Цели в области устойчивого развития

Данный стандарт разработан для достижения следующих Цель устойчивого развития

Появились вопросы?

Ознакомьтесь с FAQ

Работа с клиентами
+41 22 749 08 88

Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)