Тезис
ПредпросмотрThis part of ISO 4524 provides procedures for conducting mixed flowing gas (MFG) environmental tests involving
exposures to controlled quantities of corrosive gas mixtures.
It describes the required equipment and the methods for gas, temperature and humidity control that enable tests to
be conducted in a reproducible manner. Reproducibility is measured through the use of control coupons the
corrosion films of which are evaluated by mass gain, coulometry or by various electron and X-ray beam analysis
techniques. Reproducibility can also be measured by in situ corrosion rate monitors using electrical resistance or
mass frequency change methods.
MFG tests can be used to:
_ evaluate novel electrical contact metallization for susceptibility to degradation due to environmental exposure
to the test corrosive gases;
_ evaluate the shielding capability of connector housings that may act as a barrier to the ingress of corrosive
gases;
_ evaluate the susceptibility of other connector materials such as plastic housings to degradation from the test
corrosive gases.
MFG tests are not normally:
_ used as porosity tests (for guidance on porosity testing, see ISO 10308, Metallic coatings — review of porosity
tests);
_ applicable where the failure mechanism is other than pollutant gas corrosion such as in tin-coated separable
contacts.
-
Текущий статус: PublishedДата публикации: 2000-03
-
Версия: 2
-
- ICS :
- 25.220.40 Metallic coatings
Приобрести данный стандарт
Формат | Язык | |
---|---|---|
std 1 145 | ||
std 2 145 | Бумажный |
- CHF145
Жизненный цикл
-
Ранее
WithdrawnISO 4524-2:1985
-
Сейчас
-
00
Предварительная стадия
-
10
Стадия, связанная с внесением предложения
-
20
Подготовительная стадия
-
30
Стадия, связанная с подготовкой проекта комитета
-
40
Стадия, связанная с рассмотрением проекта международного стандарта
-
50
Стадия, на которой осуществляется принятие стандарта
-
60
Стадия, на которой осуществляется публикация
-
90
Стадия пересмотра
-
95
Стадия, на которой осуществляется отмена стандарта
-
00
Появились вопросы?
Ознакомьтесь с FAQ
Часы работы:
Понедельник – пятница: 09:00-12:00, 14:00-17:00 (UTC+1)
Будьте в курсе актуальных новостей ИСО
Подписывайтесь на наши новости, обзоры, а также на информацию о продуктах.