Résumé
This document specifies a test method for determining the shear behaviour of an adhesive in a single lap joint bonded assembly when subjected to a tensile force.
The test is performed on specimens consisting of thick, rigid adherends, with a short length of overlap, in order to obtain the most uniform distribution of shear stresses possible and to minimize other stress states which initiate failure.
This test method may be used to determine:
— the shear-stress against shear-strain curve to failure of the adhesive;
— the shear modulus of the adhesive;
— other adhesive properties that can be derived from the stress/strain curve such as secant shear modulus and maximum shear stress;
— the effect of temperature, environment, test speed, etc., on these properties.
This document does not apply in case of adhesion failure.
Informations générales
-
État actuel: PubliéeDate de publication: 2019-06Stade: Clôture de l'examen [90.60]
-
Edition: 3
-
Comité technique :ISO/TC 61/SC 11ICS :83.180
- RSS mises à jour
Cycle de vie
-
Précédemment
AnnuléeISO 11003-2:2001
-
Actuellement
PubliéeISO 11003-2:2019
Les normes ISO sont réexaminées tous les cinq ans
Stade: 90.60 (En cours d'examen)